The application of the automatic motor winding machine greatly reduces the labor cost of the enterprise and effectively improves the production efficiency and product quality of the product. At the same time, it is necessary to pay attention to the correct use of the fully automatic motor winding machine. If it is caused by negligence of operation during operation, the loss will be relatively large. Therefore, every time you start the automatic motor winding machine, you must check it first, and check and solve some possible problems in advance to avoid the occurrence of failures after operation.
1. Before the full-automatic motor winding machine is officially started, check the nameplate of the equipment, as well as the circuit connection, whether the starting device and other various devices are normal. Check whether the circuit connection of each component is accurate, whether the equipment grounding is reliable, and whether the fuse meets the relevant regulations for operation. Avoid damage to the winding machine equipment due to some low-level errors such as short circuits.
2. Check the insulation of the fully automatic motor winding machine before connecting the power supply. If the insulation resistance of the winding machine is not enough, you need to first dry it, check the insulation of the winding of the winding machine, and calibrate the pressure of the carbon brush spring, clean the slip ring And impurities on the carbon brush.
3. Before the full-automatic motor winding machine is put into operation, it must be run with a no-load trial run. During the trial operation, check the running direction of the fully automatic motor winding machine and the operation of each device component, such as whether there are some abnormal sounds and vibrations. If no problems are found after the inspection, the fully automatic motor winding machine can be operated under load.