The process of operating the automatic coil winding machine must be carried out strictly in accordance with the relevant operating rules. Incorrect operation will damage the winding machine to a certain extent. Therefore, the use of automatic coil winding machine must do the relevant maintenance work to maintain the winding machine in a better state.
The operation of the automatic coil winding machine must be careful, and do not do anything unrelated to the work during the operation of the winding machine. If there are other things to be dealt with, it is necessary to stop the operation of the winding machine, turn off the power and air source, and perform the winding machine according to the process requirements. Do not increase the wire diameter, the number of turns and the winding speed at will during the winding process. The operation of the winding machine needs to be carried out according to its set load standard, and it must not exceed its load range. Correctly clamp the spool and mold parts, and avoid increasing the torque to tighten the mold by extending the handle. The main shaft of the winding machine and the mechanical speed change of the winding organization, as well as the clamping and adjustment of the mold, need to be carried out after parking is completed. The protective equipment of the winding machine is to ensure the safety of personnel in the event of some abnormal conditions. . Therefore, the safety protection equipment on the automatic coil winding machine cannot be disassembled at will. Do not arbitrarily place other objects on the automatic coil winding machine, especially on the wire rod and the winding diameter. Pay attention to the operation of the winding machine in real time. If there are abnormal phenomena such as action failure, sensation, heat, crawling, noise, peculiar smell, bumps, etc., you need to check the parking immediately and continue to run after the problem is solved.
After the automatic coil winding machine stops running, it needs to be cleaned correctly to clean up the debris left on the winding machine during the winding process. Perform refueling maintenance on the displacement footprint of the cable and the position of the pay-off shaft, and record the information in the equipment manual.