Matters needing attention during operation of automatic needle winding machine

 Industry information     |      Aug-Thu 04:40:th

In order to avoid some situations that are not conducive to the normal operation of the automatic needle winding machine, it is necessary to monitor the automatic needle winding machine during its operation.In this way, the hidden trouble can be found as early as possible, and can be dealt with in a timely manner, to avoid greater losses caused by the expansion of the problem.

needle winding machine

1.The first step is to monitor the temperature of the automatic needle winding machine

The purpose of doing this is to avoid overheating damage. Please refer to the causes of overheating of the automatic needle winding machine.

2.Monitor the load current of the automatic needle winding machine

When the load current of automatic needle winding machine increases, the copper consumption of winding coil will also increase, and then the temperature of stator winding coil and stator core will increase.When the automatic needle winding machine is working, its load current cannot exceed the rated value on the nameplate. The temperature will directly affect the increase or decrease of the load current.

automatic needle winding machine

At the same time of increasing the load current, the balance of the three-phase current should be monitored,when the maximum value of two-phase current does not exceed the rated current value, the imbalance of each phase current should not exceed 10%.If the difference is large, then the stator winding may appear short circuit, open circuit, reverse connection and other faults or single-phase motor operation.When this kind of situation occurs, the automatic needle winding machine needs to stop running immediately, find out the cause of the problem and solve it before starting up for use.

Large capacity of the automatic needle winding machine in the control device will be installed in the current meter, so that you can immediately know the automatic needle winding machine current situation.Most of the automatic needle winding machine with small capacity do not have ammeters, but often need to use a clamp ammeter to measure them.


Contact us

Manager: Annie

Mob : 0086-15990591701

Website: www.nide-tech.com

Email :[email protected]

Address:14-5, East Kemao Center, No.100 Xiangyun Road, Hi-tech District, Ningbo, China

Scan QR code access with mobile phone
Matters needing attention during operation of automatic needle winding machine

Scan QR code access with mobile phone。