Automatic stator winding machine is a highly intelligent mechanical equipment, operation is not difficult.However, in the operation of fully automatic stator winding machine, it is necessary to know how to set three parameters, which are the starting position, enameled wire specification and winding width.
1.Setting of winding position of automatic stator winding machine
The winding position of the automatic stator winding machine is also the starting point of winding on the skeleton, which is closely related to the head of the coil and the type of coil.The measurement function in the equipment control system can be used to measure the specific value of the starting and winding position. Of course, it can also be measured manually.Take the fixed point as the reference point and use the ruler for actual measurement. Pay attention to the winding direction of the coil when setting this point.
2.Automatic stator winding machine enameled wire specification setting
There are many kinds of enameled wire diameter, the setting of enameled wire specification will affect the wiring effect of the automatic stator winding machine, and the material of enameled wire will also affect the wire diameter modification value.Copper wire is a kind of material that is not easy to be drawn down. The modification value of this material is generally increased by about 0.02. If aluminum wire is easy to be pulled up, the correction value between 0.02~0.2 is allowed.
3.Setting of winding width of automatic stator winding machine
The winding width is the distance from the beginning to the end of the winding, which directly reflects the length of the skeleton to be wound.When setting, the influence of the small deformation of the skeleton used on the width of winding should be taken into account, and the minimum value can be taken as the width of winding by means of comprehensive measurement.